Distributed Denial of Service (DDOS) Setup

Firewall can protect your port by Connection Hit, IP, DNSBL, Detection Multiple and IP Lock.

Distributed Denial of Service (DDOS) Setup

Postby admin » Mon Oct 22, 2012 12:48 am

. DDOS Detection and Protection are used to protect your service port from being attacked by hacker.
. Not like hardware router, it is port dependent. If many attacking packet arrive, it will not block all TCP packet.
. Magic Router is support TCP Flooding protection ONLY.
. If you need a UDP or ICMP detection, you can download a free DDOS Detector from our support centre.

Setting up TCP Flooding Detection and Protection:
. go to Firewall > enable IF > enable DDOS Setup,
. the first figure shows the total packet of listened port, the 2nd is total attack count.
. then select correct adapter to listen packet first.
. DDOS Packet Threshold (1-65535) is used to trigger DDOS protection. If over this threshold value in a second, MR will handle the timeout packets.
. DDOS Packet Timeout /ms (1-65535) is used to control packets are timeout or not. MR will delete half open TCP SYN packet if connection timeout, delete only if DDOS protection is triggered.
. Action, if DDOS attack, take action, run command or send email.

Page3a.JPG (25.65 KiB) Viewed 45910 times
Site Admin
Posts: 159
Joined: Wed Aug 24, 2011 8:31 am

Return to Firewall

Who is online

Users browsing this forum: No registered users and 1 guest


Download Software